1969 and up type 3 bus door handles, key fits them all . $125 shipped in the USA. Few minor pits on bottom of handle. Still shines!
dual dellorto 40 D carbs. Made in Italy. Clean inside And throttle shafts are tight However working condition are unknown. Comes with new manifolds shown below in the pics, These have been ported on both ends. Free shipping anywhere in the continental USA
$850

ragtop

complete 2 fold ragtop section , shaft a little thin where handle fits but works fine. Will need new rollers, pick up Daytona only
Ghia Hinge Cover 74 not perfect areas need some patchwork (liquid welder glue) You pay shipping.
Pop out windows 65 and later with black window welt, screws and screw rails. You can polish up, the seal is still usable. You pay shipping.
Holley Blue Pump Used been sitting for a while not sure if it works. Looks good. You pay shipping.
I have a pair of counter rotating lightly used propellers for sale. These were spare props only. Very nice condition. Selling as a pair. Yamaha SWS II stainless steel 15 1/4 X 19m L / R. $450 shipping included. Jack
Brodix Big Brody Al. Heads, 1.640 Manley S. Steel Valves, New Nextex Springs (roller), Recent V.J. , A.R.P. Studs, Comp. Push Rod Guides, C.N.C Chambers. Cost $3,595, **Asking $1,700 O.B.O** Located in Daytona Beach, Fl Calls Only / No Texts - 973-931-3475. New Nextex Rollers Springs, Stainless Steel Valves, Comp. Push Rod Guides. Daytona Beach, FL, FL 32114 (973) 931-3475
Gene Berg 580 Manifolds not ported. Weber IDF or Dellorto, also drilled for Solex 40 P11 carbs. Studs for Solex will need to be drilled out. Weber IDF / Dellorto just needs studs.
Weber IDF Dual Manifolds Ported missing one stud. You pay shipping.
Dellorto Dual 45 Drla Carburetors need rebuild. You pay shipping.
Euro Bumper Guards been sitting for a while aftermarket. Will polish up nicely. $20.00 shipped. Only two.
These 3 Good Used Diff's all have tight ring and pinion backlash. These all have the higher gear ratio of the Type 3 rather than the Type 4. As you may know, the diff's went bad when transaxle fluid leaked past torque converter seal and mixed with the 80-90w oil of diff.
I have 6 Type 3 Good Used Flex Plates. I saved these thru the years in case i needed one for a service job. I retired and closed my shop here in Daytona Beach, FL so now someone else can have them.
This was rebuilt by a transmission shop here in Daytona Beach, FL. I retired and closed my store after 22 yrs. I always kept a fresh transaxle in parts room for future service work to shorten the turn around time for customer. I also have a Rebuilt Torque Converter that was done at same time. I can strap to a pallet for shipping. You pay shipping. Call me at 1-386-299-8081 for more details or [...
These 2 Torque Converters are Good Used. The oil in then does Not sell burnt as it would if used with a burnt up Tranaxle. You pay shipping and can be shipped in a plastic tote sealed with duct tape. Call me at 1-386-299-8081.